Buy Mercury Parts
Buy Mercury Marine Outboard Parts

Announcement

Collapse
No announcement yet.

Motor Alarm

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Motor Alarm

    Good morning,
    I have a 2005 Mercury 40 2-stroke and the motor alarm just came on out of nowhere. The water flow is fine, oil seemed to be being pumped fine, it wasn't over heated as I have just started it and the alarm came on about one minute later. There were a few weeds in the area but the motor was clean and not plugged. Does anyone have any ideas what could be the problem? The only issue I can think of is my oil pump gave out. I can't find anywhere any information on these "alarms". To be honest, I didn't even know it had an alarm! Any help would be appreciated. Thanks.

  • #2
    There is a sensor on oil pump drive shaft and if shaft is not turning oil pump then will activate alarm. If any don't about oil injection system then 50:1 oil mix to gas tank until know everything is working properly.
    Regards
    Boats.net
    Mercury Outboard Parts
    MerCruiser Parts
    Force Outboard Parts
    Mariner Outboard Parts

    Comment


    • #3
      Connect diagnostic software to see what the fault codes read. That's the quickest and easiest way to know exactly what it is.

      Comment

      Working...
      X