hello all , i have this motor that was givin to me , been sitting 2 yrs , i tried to crank it , starter solonoid is bad , jumped straight to starter it turns over , has fire but wont start . where do i go from there ? noticed oil coming out of the prop that seal is bad,i know to change water pump . i want to here it at least try to fire before i spend a bunch of money on it / thanks for the help in advance Tim
Announcement
Collapse
No announcement yet.
1979 1150 140 hp
Collapse
X
-
Start with a compression test to see if all cylinders are even, if ok then probably will need to remove and clean carbs and fuel system.Regards
Boats.net
Mercury Outboard Parts
MerCruiser Parts
Force Outboard Parts
Mariner Outboard Parts
-
On any engine that has been setting, a carb clean and rebuild is mandatory in my book. If fuel was left in carbs the fuel will evaporate and leave the oil residue behind forming a hard gum/varnish. Here is what I would do before investing any monies in motor.
(1) Check compression on all 6 cylinders, it should be 100psi or higher. All cylinders should be within 10 psi of each other, if OK proceed to step 2
(2) Check all 6 cylinders for proper spark, that ignition system should be able to a 3/8 air gap and be bright blue,if not check ignition system
(3) Check lower unit for water and excess metal particles in oil
(4) Remove carbs and clean/rebuild each
(5) Replace fuel pump diaphram and any degraded or stiff fuel lines
(6) Replace impeller
Comment
Comment