Merc 110 (9.8 hp) impeller replacement

[Jeff Filson]

Hello,
I need to replace the impeller on this outboard.
I have no manual and have never done this before, but I am a very capable mechanic.I was hoping someone could help me out with a picture or an explanation on where this separates and how. what to be careful of/look for etc.
I had it replaced a few years ago and I hate waiting on other people to do a job when I can do it myself. Can anyone help me out with this?
Thanks in advance,
Jeff

[JUST-IN-TIME]

shoot me an e-mail

[a69mopar]

110 9.8 impeller change

I would appreciate any help with this service also.
Thanks,
Wayne

[troye]

Was wondering if I could get a little help as well -impeller

Never done it.
Dad's boat out of the water for many years. Tried to start it today and it started but the water was not flowing correctly.

[Bernie Hill]

Also would like information

Would like to replace water pump in Merc 110 9.8hp. Do not have repair manual or diagrams. Thanks for any inf and/or where to get a schematic of the motor.

[JUST-IN-TIME]

Would like to replace water pump in Merc 110 9.8hp. Do not have repair manual or diagrams. Thanks for any inf and/or where to get a schematic of the motor.

shoot me an email i have the factory manuals

[Rover 310]

Fantastic Mercury 9.8hp in need of your help

Hi Guys

I've got a great old Merc 9.8 that needs an impeller change, I've had this motor for years and its been a beaut but I now want to take my 5 year old boy out and have been thinking about reliability perhaps more seriously.

I am having trouble dropping the gearbox, it is loose but wont come away, I have taken the plugs out and checked the gears by turning the engine over and the're fine. Is there a gear linkage that I need to disconnect.

Any help would be greatly received.

Rover 310

[Rodneybr]

I can't remove the bottom unit to check the impeller

Gentlemen

I have removed the two nuts that I believe is holding the bottom unit in place but I am not able to seperate the bottom unit. Did I miss a nut/screw?

If I didn't miss a nut\screw then how do I get the bottom unit to drop?

Can you also provide a link to the right replacement impeller? I see two options but I don't know which to chose [ 9.8 11 TWIN, 1967, red pin stripe]