1985 Mariner 25 HP

[racerxv6]

Can someone please assist me in locating the idle adjustment screws on this motor. I know that there is a screw at the base of the front of the carburetor in a black plastic lever, but I am not sure if that is one of them. I also know that there is a screw that is that is just above the air intake that seems to be a needle valve type.

Any help would be appreciated! I am going to buy a Seloc manual here in a few.

Thanks,
Racerxv6

[Elbo]

There should be a white plastic rocker plate on the left side of the motor with a screw in it.Thats it.

[racerxv6]

Hey Eveyone,
Found the idle screw and adjusted accordingly. Will ge out on the water this week. I also wanted to comment on a fuel issue I was having. While running full throttle the motor would almost die an then pick back up and run for a little bit 30-4o- seconds or so and then die again. I changed the primer ball and no luck, checked all hoses on the motor and everything looked good. Finally decided to check the pick up in the tank and to my surpise the pickup tube was about 1/2 inch to long. The tube was actually bent in half and was not allowing the fule to stay at a constant pressure to allow the flow to the motor.

Hope this helps anyone out there battling s similar issue.

Matt