If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
My Tach is not working, havent put the boat in water yet , but ran on water hose, in neutral. Tach is not moving, anyone know where to start, checking..
Thanks
There is usually a roughly a 2 X 2 inch black module (puck) mounted on the starboard side of the (Mid Section) power head.
You can tell this by the wires coming down from the Stator (Under Flywheel) , There is usually a Grey wire-lead coming from this module. This should be a Tach output.
Be careful when engine is running this is a charging (Electric) circuit to charge on board starter battery.
Put a external charger on the battery and see if the battery has been charging properly,, if not,, more than likely the Tach stops working side of the rectifier is malfunctioned..
I hope this helps..
Comment